![sram bleeding edge procedure sram bleeding edge procedure](https://www.parktool.com/assets/img/repairhelp/Brake-Bleeding-Edge-Port-Tightening.jpg)
Thread the screw originally holding the pads through the block.ĥ. Put the pistons into the caliper body via a special tool or tire levers and then slide a bleeding block between the pistons. Tip: Wrap the brake pads in a clean, dry paper towel.Ĥ. Remove the brake pads and put them in a place where they cannot be contaminated. If you’re bleeding the rear brake, the movement of the fluid can be facilitated by lifting the front end of the bike and positioning the entire frame perpendicularly to the floor.ģ. If you’re bleeding the front brake, just putting the bike in a stand will be enough. Position the bike in a way that will ensure consistent travel of fluid between the caliper and the brake lever. Bring the brake lever away from the grip as much as possible via the reach adjustment screw.Ģ.
![sram bleeding edge procedure sram bleeding edge procedure](https://bikerumor.com/wp-content/uploads/2017/07/SRAM-s900-HRD-hydraulic-disc-brake-aero-tri-brake-lever-caliper-7-768x512.jpg)
The bleeding process of Shimano flat bar hydraulic brakes is as follows:ġ. a hose with a compression sleeve/slip stopper.Differences Between SRAM and Shimano Brake BleedingĪn average Shimano bleed kit includes the following parts: Nonetheless, it’s advisable to acquire a proper Shimano bleed kit for a more convenient, safer, and faster bleeding process.Īlso, do not rely on a used SRAM kit to bleed Shimano brakes because the two systems use different fluids, and there are chances of contamination. That said, it’s possible to use parts of a SRAM bleed kit on Shimano brakes and bleed them successfully. The bleeding kits designed for each brand reflect the dissimilarities. Condensed Answer: SRAM and Shimano hydraulic brakes require a different bleeding process.